Cylinder Saddle Bracket Mount Kits

The CMK 'SADDLE' type bracket cylinder mounting kit is a rigid, one peice low-profile, high-strength method of securing CFFC-048, KF-050 and KF-115 composite-fiber cylinders to a flat surface. With the CMK brackets bolted in place, the cylinder is held into place by a set of Quick Release Stainless Steel taut-bands. (Kits come standard with rubber cylinder cushion and Knob) (Set of Two)

 00CMK-0006-13-008000CMK-0006-13-0067

Read more...

CMK Omega Cylinder Mounting Kits

CHEX-2The CMK 'OMEGA' type bracket cylinder mounting kit is a rigid, low-profile, high-strength method of securing aluminum or composite-fiber cylinders to a flat surface. With the CMK brackets bolted in place, the cylinder is held into place by a set of stainless steel taut-bands. (Kit comes standard with mounting feet and Knob) (Set of Two)

 


 

 

 

 

Read more...

Full Pack

Seat-Back-4FULL-PACK: A fully padded carry case for any of our portable cylinders. A GoreTex padded-fabric harness allows you to safely carry the cylinder. All Full-Pacs come with a set of straps and quick clips placed about the harness that allows you to mount the cylinder to a structure such as a seat back. When zipped, the Full-Pack holds and totally covers the cylinder, valve, and regulator adding to your comfort, convenience and safety.

Read more...

Remote Fill Stations

Click on Photo to see Remote Fill Stations.

Fill_Stations-72

Cylinder Valve Heads

Valve-head_Dem


Below is the line-up of our most common cylinder valve heads.
Photo shows the USA standard CGA-540 gauged valve, (on cylinder) and the European standard DIN-477#9 valve.

 

 

 

Read more...

Low Profile Manifold

MH Low Profile -High Pressure pick off manifolds. Can be Cylinder or Bulk-Head mounted.
The Low-Profile manifolding system provides you with the ability to remotely mount your regulator from the cylinder. This is ideal where the cylinder may need to be mounted in a tight area where the regulator assembly would be too hard to reach of not fit. Additionally, this gives you the ability to cascade cylinders in your custom built-in system.

LPM75_-CYL-and-HPQDMAN-0024_LPM-75

Read more...

Tuff-Pack

TuffPack-07These specially-designed Tuff-Packs make it easy to hold and contain KF series cylinders. All Tuff-Packs have "D" rings placed at balance points to allow for rear-seat mounting.

 

Read more...

MH01-052

 
MH-1regulatorThe MH01-052 is a thread interface/transition adapter that allows the replacement of an original steel cylinder with a new lighter kevlar type without replacing or disturbing any of the original regulating, refilling and delivery equipment or lines.
If you are planning on replacing your steel cylinder with a kevlar cylinder in a certified airplane you must read the following PDF file.

 

Read more...